diff options
Diffstat (limited to 'README.md')
| -rw-r--r-- | README.md | 11 |
1 files changed, 7 insertions, 4 deletions
@@ -21,9 +21,11 @@ Because zenpower is using same PCI device as k10temp, you have to disable k10tem 1. Check if k10temp is active. `lsmod | grep k10temp` 2. Unload k10temp `sudo modprobe -r k10temp` -3. (optional) blacklist k10temp: `sudo bash -c 'sudo echo -e "\n# replaced with zenpower\nblacklist k10temp" >> /etc/modprobe.d/blacklist.conf'` +3. (optional*) blacklist k10temp: `sudo bash -c 'sudo echo -e "\n# replaced with zenpower\nblacklist k10temp" >> /etc/modprobe.d/blacklist.conf'` 4. Activate zenpower `sudo modprobe zenpower` +*If k10temp is not blacklisted, you may have to manually unload k10temp after each restart. + ## Sensors monitoring You can use this app: [zenmonitor](https://github.com/ocerman/zenmonitor), or your favourie sensors monitoring software @@ -38,6 +40,7 @@ You can use this app: [zenmonitor](https://github.com/ocerman/zenmonitor), or yo ## Help needed It would be very helpful for me for further development of Zenpower if you can share debug data from zenpower. [Read more](https://github.com/ocerman/zenpower/issues/12) -## Known Issues - - On some systems the SVI2 values for Core/SOC may be swapped. As a workaround you can install module with `sudo make dkms-install MCFLAGS=-DSWAP_CORE_SOC` to swap them back. (Should be fixed in version 0.1.4) - - The formula for calculating amperage/wattage from raw values may not be correct for all systems. (Should be fixed for Zen2 Ryzen CPUs in version 0.1.4) +## Notes + - Some users reported that a restart is needed after module installation + - If you are having trouble compiling zenpower under Ubuntu 18.04 (or older) with new upstream kernel, see [#23](https://github.com/ocerman/zenpower/issues/23) + - The meaning of raw current values from SVI2 telemetry is not standarised so the current/power reading may not be accurate on all systems (depends on the board model). |